• Publications
  • Influence
A study on Quality of Experience for adaptive streaming service
  • 56
  • 6
Near-Optimal Equalizer and Timing Adaptation for I/O Links Using a BER-Based Metric
TLDR
A new adaptation strategy of I/O link equalizers is presented based on minimizing the bit error rate (BER) as the objective function to maximize the receiver voltage margin. Expand
  • 43
  • 4
H2B: Heartbeat-based Secret Key Generation Using Piezo Vibration Sensors
TLDR
We present Heartbeats-2-Bits (H2B), which is a system for securely pairing wearable devices by generating a shared secret key from the skin vibrations caused by heartbeat. Expand
  • 14
  • 3
  • PDF
Accurate System Voltage and Timing Margin Simulation in High-Speed I/O System Designs
TLDR
We introduce an accurate jitter modeling technique which accounts for bounded jitter with arbitrary spectrum in addition to Gaussian jitter. Expand
  • 36
  • 2
  • PDF
A 5 Gb/s Link With Matched Source Synchronous and Common-Mode Clocking Techniques
TLDR
A 5 Gb/s source-synchronous signaling system was developed utilizing a new clock/data skew minimization technique. Expand
  • 20
  • 2
KEH-Gait: Towards a Mobile Healthcare User Authentication System by Kinetic Energy Harvesting
TLDR
In this paper, we present KEHGait, which advocates use of output voltage signal from kinetic energy harvester (KEH) as the source for gait recognition. Expand
  • 35
  • 1
  • PDF
A 5Gb/s link with clock edge matching and embedded common mode clock for low power interfaces
TLDR
A new clock/data skew minimization technique with a source-synchronous transmit clock delay line and integrating receiver tolerates high frequency transmit clock jitter and supports rapid turn-on without the clock buffer latency of conventional source synchronous systems. Expand
  • 2
  • 1
Precursor ISI Reduction in High-Speed I/O
TLDR
We show that with decision-feedback equalization (DFE) handling postcursor inter-symbol interference (ISI), cancelling precursor ISI with transmitter equalization degrades rather than improves performance. Expand
  • 20
  • PDF
Effects of ultrasonic treatment and current density on the properties of hydroxyapatite coating via electrodeposition and its in vitro biomineralization behavior.
In this study, ultrasonic-assisted electrodeposition is used to prepare uniform and smooth hydroxyapatite (HA) coating on the surface of the braids, which can be potentially applied as biodegradableExpand
  • 16
Spongy Materials Based on Supramolecular Polymer Networks for Detection and Separation of Broad-Spectrum Pollutants
By rationally introducing multi-interactions sites, supramolecular polymer networks (SPN-TDPG) has been successfully designed and constructed. SPN-TDPG gel shows aggregation-induced emission,Expand
  • 11