• Publications
  • Influence
Preparation and characterization of carbon nanotubes/aluminum matrix composites
Abstract 2024Al matrix composite reinforced with 1 wt.% carbon nanotubes (CNTs) was fabricated by cold isostatic pressing, followed hot extrusion techniques. The microstructure characteristics andExpand
Exploring the role of reinforcement in controlling fatigue crack propagation behavior of perfluorosulfonic-acid membranes
Abstract Reinforced composite membranes in polymer-electrolyte fuel cells (PEFCs) are attracting more and more attention due to their simultaneously superior durability and high performance. DespiteExpand
Tribological behaviour of AZ71E alloy at high temperatures
Abstract Tribological behaviour of the die-cast AZ71E magnesium alloy was investigated in an applied load range of 10–50 N at high temperatures under dry sliding conditions using a pin-on-disc wearExpand
In-plane biaxial ratcheting behavior of PVDF UF membrane
Abstract A series of in-plane biaxial cyclic tests were conducted to investigate the biaxial ratcheting behavior of polyvinylidene fluoride (PVDF) ultrafiltration (UF) membranes via cruciform shapedExpand
In-plane biaxial cyclic mechanical behavior of proton exchange membranes
Abstract The durability of a proton exchange membrane is affected by both mechanical degradation and chemical degradation. While fatigue and relative humidity cycling tests have been conducted toExpand
Investigation of Tribological Properties of Magnesium Alloys under Dry Sliding and Lubrication Condition
The friction and wear characteristics of three magnesium alloys, AZ91D, AS41, and AZ71E, under dry sliding and lubricated conditions were investigated. The results indicate that friction coefficientsExpand
Biaxial fatigue crack propagation behavior of perfluorosulfonic-acid membranes
Abstract Perfluorosulfonic-acid membranes have long been used as the typical electrolyte for polymer-electrolyte fuel cells, which not only transport proton and water but also serve as barriers toExpand
Effect of surface mechanical attrition treatment on corrosion fatigue behavior of AZ31B magnesium alloy
Abstract Surface mechanical attrition treatment (SMAT) is considered as an effective technology to influence fatigue and corrosion resistance as these properties are largely related to surfaceExpand
Research on the densification of W-30 wt%Cu composite powder by hot extrusion with steel cup
Abstract The W-30 wt%Cu composite bars and strips were obtained by hot extrusion with steel cup from spray-drying powders. The relative density of cold-compressed billets is about 71.4%, and afterExpand
Fracture property of Nafion XL composite membrane determined by R-curve method
Abstract The durability of perfluorosulfonic-acid membranes have long been the barrier for commercialization of polymer-electrolyte fuel cells. Pinholes/cracks are the typical features that impairExpand
...
1
2
3
...