• Publications
  • Influence
Engineering of surface layer in material removal machining
Abstract Methodology developed for designing and investigation of the characteristics of technological and exploitation surface layer aiming to provide conditions under which a surface layer withExpand
  • 4
  • 1
A New Parameter of Statistic Equality of Sampling Lengths in Surface Roughness Measurement
This paper presents the procedure for obtaining the primary profile, the waviness profile, and the roughness profile when measuring surface roughness, based on a set of recommendations from severalExpand
  • 9
  • 1
  • PDF
Development of mathematical models for surface roughness parameter prediction in turning depending on the process condition
Abstract This paper presents mathematical models for predicting R z , R p , R v , R a , R S m and R m r ( c ) roughness parameters based on the kinematical–geometrical copying of the cutting toolExpand
  • 17
Economic aspects of cutting with diamond-coated wire
Cutting with diamond-coated wire is of a great importance at shaping hardly workable materials. As the time goes by, due to the tool wear, cutting abilities of diamond wire are reduced up to 50%.Expand
  • 3
Experimental studies of the cutting force and surface morphology of explosively clad Ti–steel plates
Abstract The present work pertains to the study of clad material such as titanium plated steel in drilling process. The study was conducted for two types of indexable insert drills with differentExpand
  • 56
Modeling and prediction of surface roughness profile in longitudinal turning
Abstract This paper presents the methodology for modeling and predicting the roughness profile shape in longitudinal turning. The research considers the roughness profile as the sum of two profilesExpand
  • 4
Correlation between the fracture roughness and fatigue threshold of high-temperature degraded steel
We analyze the influence of degradation of 12Kh1MF heat-resistant steel under in-service and laboratory conditions on the characteristics of surface roughness after fatigue fracture. It is shown thatExpand
  • 3
Mathematical modeling of maximum height of roughness profile in turning with using wiper insert geometry
* Ass. Prof. Mite Tomov, Ph.D. (mite.tomov@mf.edu.mk), Prof. Mikolaj Kuzinovski Ph.D. (mikolaj.kuzinovski@mf.edu.mk) – Ss. Cyril and Methodius” University in Skopje Faculty of MechanicalExpand
  • 1
  • PDF
Reducing of process model uncertainty towards smart machining systems
TLDR
This paper presents an approach of empirical modeling of cutting process physical phenomena with measurement uncertainty parameters accompanied to the model exponents/coefficients. Expand
  • 1
  • PDF
Sinker electrical-discharge machining of aluminium matrix composites
Principal features of aluminium matrix composites are put forward. Emphasis is put on temperatures of melting and coefficients of heat conduction of matrix and reinforcement. The paper presentsExpand
  • 13
  • PDF
...
1
2
3
4
...