• Publications
  • Influence
Trends in the Development of Machinery and Associated Technology ” TMT 2010 , Mediterranean Cruise , 11-18 September 2010 TENSILE PROPERTIES OF TWO Al-Mg WELDED PLATES AFTER APPLYING DIFFERENT
Two Al-Mg alloys: (I) AA5182 type and (II) the same type additionally alloyed with a low amount of Zn and Zr (≈ 0.12%wt each) were processed to 6.5mm thick H116 and H321 marine grade plates. TheyExpand
INFLUENCE OF THE THERMO-MECHANICAL TREATMENT ON THE EXFOLIATION AND PITTING CORROSION OF AN AA 5083-TYPE ALLOY
Exfoliation and pitting corrosion were tested on an AA5083-type alloy sheet, after applying different thermo-mechanical treatments. Hot-rolled plates were laboratory cold rolled with 16–54 %Expand
  • 1
  • PDF
Trends in the Development of Machinery and Associated Technology ” TMT 2011 , Prague , Czech Republic , 12-18 September 2011 MECHANICAL PROPERTIES OF TWO Al-Mg WELDED PLATES AFTER APPLYING DIFFERENT
Two Al-Mg alloys: (I) AA5182 and (II) AA5182+Zn and Zr (≈ 0.12%wt each) were processed to 6.5mm thick H116 and H321 marine grade plates. They were welded by applying Metal Inert Gas – 131, (MIG) andExpand
  • 2
  • PDF
Stability Areas During Quiet Standing
The experiments performed in our laboratory revealed that able-bodied subjects use four different high-level control strategies to maintain stable quiet standing, and that there is a directExpand
Trends in the Development of Machinery and Associated Technology ” TMT 2009 , Hammamet , Tunisia , 16-21 October 2009 STRAIN STATE EFFECT ON THE SURFACE RELIEF APPEARANCE IN THE DEFORMED Al-Mg ALLOY
The Al-Mg alloy sheets containing 6.8 wt.% Mg were tested under different stretching conditions (uniaxial, plain-strain and balanced biaxial) in order to make some surface roughness created by typeExpand