Learn More
This document specifies an architectural framework for the application of Multiprotocol Label Switching (MPLS) to the construction of packet-switched transport networks. It describes a common set of protocol functions-the MPLS Transport Profile (MPLS-TP)-that supports the operational models and capabilities typical of such networks, including signaled or(More)
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.(More)
This document describes an architecture for extending pseudowire emulation across multiple packet switched network (PSN) segments. Scenarios are discussed where each segment of a given edge-to-edge emulated service spans a different provider's PSN, as are other scenarios where the emulated service originates and terminates on the same provider's PSN, but(More)
This document specifies a mechanism to signal Pseudowire (PW) status messages using a PW associated channel (ACh). Such a mechanism is suitable for use where no PW dynamic control plane exits, known as static PWs, or where a Terminating Provider Edge (T-PE) needs to send a PW status message directly to a far-end T-PE. The mechanism allows PW Operations,(More)
This document specifies an Inter-Chassis Communication Protocol (ICCP) that enables Provider Edge (PE) device redundancy for Virtual Private Wire Service (VPWS) and Virtual Private LAN Service (VPLS) applications. The protocol runs within a set of two or more PEs, forming a Redundancy Group, for the purpose of synchronizing data among the systems. It(More)
The information in this publication is believed to be accurate as of its publication date. Such information is subject to change without notice and The ATM Forum is not responsible for any errors. The ATM Forum does not assume any responsibility to update or correct any information in this publication. Notwithstanding anything to the contrary, neither The(More)
RFC 5254 describes the service provider requirements for extending the reach of pseudowires (PWs) across multiple Packet Switched Network domains. A multi-segment PW is defined as a set of two or more contiguous PW segments that behave and function as a single point-to-point PW. This document describes extensions to the PW control protocol to dynamically(More)
The Multiprotocol Label Switching Transport Profile (MPLS-TP) is the common set of MPLS protocol functions defined to enable the construction and operation of packet transport networks. The MPLS-TP supports both point-to-point and point-to-multipoint transport paths. This document defines the elements and functions of the MPLS-TP architecture that are(More)