• Publications
  • Influence
Buckling of centerline-stiffened plates subjected to uniaxial eccentric compression
A solution for the elastic buckling of flat rectangular plates with centerline boundary conditions subjected to non-uniform in-plane axial compression is presented. The loaded edges are simplyExpand
  • 15
  • 1
CFRP strengthened steel beams: Improvement in failure modes and performance analysis
The externally bonded CFRP strengthened steel C channel beams were tested in this study to understand the improvement in failure modes. Two different CFRP strengthening methods were proposed: 1)Expand
  • 16
  • 1
Elastic buckling of I-beam flanges subjected to a linearly varying stress distribution
Abstract Lateral forces or torsion combined with major axis bending result in a stress gradient across the compression flanges of I-shaped flexural members. Sources that cause significant stressExpand
  • 7
  • 1
Stability of Curved Bridges During Construction
Because of the increasing demand for curved bridges combined with challenges of design and construction there is need to improve practices for the efficient design and construction of curved bridges.Expand
  • 6
  • 1
  • PDF
Enhancing the structural performance of steel channel sections by CFRP strengthening
The aim of this test study was to achieve an in-situ strengthening technique to retrofit the deteriorated tall steel structures using carbon fiber-reinforced polymer (CFRP). A total of 20 structuralExpand
  • 10
  • 1
Theoretical Evaluation of Flange Local Buckling for Horizontally Curved I-Girders
Curvature greatly complicates the behavior of horizontally curved steel plate girders used in bridge superstructures. The warping stress gradient across the width of I-girder flange plates reducesExpand
  • 6
  • 1
Definition of Flange Compactness for I-Beams that are subjected to Combined Primary Bending and Torsion or Lateral Flexure
I-shaped flexural members can be subjected to significant lateral forces or torsion combined with major axis bending. This condition commonly occurs with bridge girders that are skewed or curved inExpand
  • 1
  • 1
Progressive failure analysis of CFRP laminate with interacting holes under compressive loading
Composite structures such as hull of a ship and wings of aircraft are subjected to compressive loading. The behavior and strength of carbon fiber-reinforced polymer (CFRP) panels subjected to tensileExpand
  • 13
  • 1
Design and Construction of Modern Curved Bridges
The overall objectives of this project were to investigate and synthesize state-of-the-art practice for the efficient design and construction of curved bridges, and to identify research needsExpand
  • 9
  • PDF
...
1
2
3
4
5
...