- Full text PDF available (1)
To date, piezoelectric transformers (PTs) have been extensively commercialised in step-up applications, such as cold cathode fluorescent lamp backlighting for LCDs. As step-down PT technology matures, PT-based converters are set to replace conventional transformers and power converters in a wide variety of applications that require relatively low power… (More)
Conventional converters for radio frequency induction heating usually follow an AC-DC-AC structure, which can exhibit non-unity power factor and introduce large harmonic currents into the utility supply. The need for a direct converter for radio frequency induction heating, featuring unity power factor, and sinusoidal input current, has motivated the… (More)
Traditionally, multilevel converters are utilised in medium voltage applications, allowing the DC-link voltage to exceed the switch maximum blocking voltage. Here, their application to control high- efficiency brushless permanent magnet synchronous machines exhibiting low phase inductance is explored, the relative advantages being shown to include reduced… (More)
This paper compares the newly developed single-phase matrix converter and the more conventional H- bridge converter for radio frequency induction heating. Both the converters exhibit unity power factor, very low total harmonic distortion at the utility supply interface, good controllability under soft switching condition for a wide range of power, and high… (More)
The paper describes a new three-phase to single-phase matrix converter featuring unity input power factor, very low input total harmonic distortion, and soft-switching over the full power range, for high frequency induction heating applications. A variable output pulse density modulation scheme has been proposed for stable operation of the converter, with… (More)
A methodology for the design of LCC resonant current-source converters, is presented. Unlike previous techniques, the resulting converter provides near constant steady-state output current over an extended load range when excited at the resonant frequency, through use of a self-oscillating controller.
A multilevel BLDC drive is proposed using cascaded H-bridges with isolated sources to provide superior output waveforms and reduced current ripple whilst incorporating observer based SoC estimation. Energy management, based on SoC, is incorporated to improve battery performance, reduce variation between cells and to control charge/discharge profiles.
This paper presents a methodology for tuning a PID-based feedback controller for a buck converter using the ITAE controller performance index. The controller parameters are optimized to ensure that a reasonable transient response can be achieved whilst retaining stable operation. Experimental results demonstrate the versatility of the on-line tuning… (More)
The extended Kalman filter (EKF) is proposed as a candidate methodology to eliminate the requirement for isolated feedback sensors (components that contribute to complexity, component count and cost), for the closed-loop regulation of 3<sup>rd</sup>-order LCC resonant power supplies. Unlike previously reported methodologies it is shown that the proposed… (More)
An improved control strategy for LCC current-output resonant converters is proposed. Small/large- signal converter models and the steady-state dynamics of the converter are used for controlling power- factor. The proposed method provides a convenient, linear control mechanism for the design of regulators, which has a similar influence to varying the DC-link… (More)