Laurent Claudon

Learn More
Magneto-Inertial Measurement Unit sensors (MIMU) display high potential for the quantitative evaluation of upper limb kinematics, as they allow monitoring ambulatory measurements. The sensor-to-segment calibration step, consisting of establishing the relation between MIMU sensors and human segments, plays an important role in the global accuracy of joint(More)
As a marked increase in the number of musculoskeletal disorders was noted in many industrialized countries and more specifically in companies that require the use of hand tools, the French National Research and Safety Institute (INRS) launched in 1999 a research project on the topic of integrating ergonomics into hand tool design, and more particularly to a(More)
Following a brief description of the problem of musculoskeletal disorders (MSDs) in the meat industry and use of knives, this paper presents a study of the influence of the main intrinsic technical characteristics of a knife on its cutting performance. This study prompted design of a specific system for measuring initial cutting capacity and cutting edge(More)
Ten subjects were asked to apply maximum torques on knife handles with either their bare hand or their hand wearing a Kevlar fibre protective glove. Four knife handles (2 roughnesses, 2 hardnesses) were tested. Surface electromyograms of 6 upper limb and shoulder muscles were recorded and subject opinions on both knife handle hardness and friction in the(More)
The aim of the present study was to develop a relationship to evaluate grip force using the electromyogram (EMG) in isometric anisotonic conditions. The EMGs of the flexor digitorum superficialis (FDS) and the extensor digitorum (ED) were recorded in 3 flexion-extension positions of the wrist (30 degrees flexion, 30 degrees extension, and 60 degrees(More)
The development of ergonomic tools responds to health protection needs on the part of workers, especially the work related musculoskeletal disorders of the upper limbs and to the development of ergonomic tools to take into account the needs of the factories. Only an ergonomic design process can enable tool manufacturers to meet these requirements. Three(More)
  • 1