Keshmiri Hossein

Learn More
This paper describes the wear mechanism and tool life when machining Hastelloy C-22HS with coated carbide. The experiment was conducted using four different cutting tool materials under wet condition – namely, Physical Vapor Deposition (PVD) coated with TiAlN; TiN/TiCN/TiN; Chemical Vapor Deposition (CVD) coated with TiN/TiCN/Al2O3; and TiN/TiCN/TiN – to(More)
Cutting fluids, usually in the form of a liquid, are applied to the chip formation zone in order to improve the cutting conditions. Cutting fluid can be expensive and represents a biological and environmental hazard that requires proper recycling and disposal, thus adding to the cost of the machining operation. For these reasons dry cutting or dry machining(More)
In this paper, an analytical and simulation solution for touch mode Micro-electromechanical systems pressure sensor operating in harsh environment is proposed. The principle of the paper is to design, obtain analytical solution and compare the results with the simulation using finite elements analysis for a circular diaphragm deflection before and after(More)
This paper presents results for forward and reverse kinematics and workspace analysis of a proposed RPRPR 2.5D planar parallel manipulator using a geometric approach. The design has a potential to be adapted to diverse tasks implementable on a planar platform. The mechanism which is made up of two independent limbs of two bar linkages is capable of(More)
  • 1