• Publications
  • Influence
Preparation and tribological properties of nanoparticle lanthanum borate
Abstract Nanoparticle amorphous lanthanum borate with a particle size of 20–40 nm was prepared with a Replacing Solvent Dry technique and characterized using TEM and XRD. Its tribological propertiesExpand
  • 99
  • 3
A new active steroidal saponin from Anemarrhena asphodeloides.
A new active steroidal saponin, anemarsaponin B, was isolated from the rhizomes of Anemarrhina asphodeloides. The structure of anemarsaponin B was elucidated asExpand
  • 11
  • 1
Study on antiwear and reducing friction additive of nanometer ferric oxide
Abstract Amorphous ferric oxide with a particle size of about 20–50 nm was prepared using the ethanol supercritical fluid drying technique. The tribological properties of 500 SN oil containingExpand
  • 95
Preparation and tribological properties of nanometer magnesium borate as lubricating oil additive
Nanoparticle magnesium borate with a particle size of about 10 nm was prepared using ethanol supercritical fluid drying technique and was characterized with TEM, XRD and X-ray small angle scattering.Expand
  • 173
Study on antiwear and reducing friction additive of nanometer cobalt hydroxide
morphous rohalt hydroxide with a particle size of about 30-50 nm was prepared singan ellcal properties of a 500 SN oil containing the nanometer particles were measured using a four ball andExpand
  • 18
Study on Antiwear and Reducing Friction Additive of Nanometer Aluminum Borate
Crystalline aluminum borate with a particle size of 5-15 nm was prepared using an ethanol supercritical fluid drying technique. Tribological properties of 500 SN oil containing the nanometer aluminumExpand
  • 24
Fabrication and Characterization of Electrospun Nano to Microfiber Made of Poly(L-Lactide-co-ε-Caprolactone)
This project aims to optimize the process parameters for fabricating Poly (L-Lactide-co-ε-Caprolactone) (PLCL) electrospun scaffolds to achieve fiber diameters within the ranges of ~500nm, 500nm~1µmExpand
  • 1
THE SEGREGATION OF SULFUR AND PHOSPHORVS IN NICKEL-BASE ALLOY 718
  • 2
The effect of Sr and Fe additions on the microstructure and mechanical properties of a direct squeeze cast Al-7Si-0.3Mg alloy
This article describes the results of an investigation into the microstructure and mechanical properties of a gravity die cast and direct squeeze cast LM25 alloy (Al-7Si-0.3Mg-0.3Fe). The directExpand
  • 18