• Publications
  • Influence
Design and analysis of micromechanical tunable interferometers for WDM free-space optical interconnection
This paper proposes a new concept of high density chip-to-chip optical interconnection based on wavelength division multiplexing (WDM), which can be realized as a microelectromechanical system (MEMS)Expand
  • 18
  • 1
Optical and structural proprieties of nc-Si:H prepared by argon diluted silane PECVD
Abstract Using argon as a diluent of Silane, hydrogenated amorphous and nanorocrystalline silicon films Si:H were prepared by radio-frequency (13.56 MHz) plasma enhanced chemical vapor depositionExpand
  • 16
  • 1
Superparamagnetic Fe3O4 nanoparticles, synthesis and surface modification
Abstract Magnetite nanoparticles have been synthesized through a co-precipitation of iron (Fe3+ and Fe2+), and were characterized using Fourier-transform infrared spectroscopy (FT-IR), X-rayExpand
  • 31
MEMS Scanning Calorimeter With Serpentine-Shaped Platinum Resistors for Characterizations of Microsamples
We report a new design and operation of a microelectromechanical systems (MEMS) differential scanning calorimeter (DSC) for heat-capacity measurements. The sensor consists of a 500-nm silicon nitrideExpand
  • 11
Structural and Optical Characterization of ZnO Thin Films Deposited by Reactive rf Magnetron Sputtering
The aim of this study is to obtain high-quality zinc oxide thin films at room temperature by reactive radiofrequency (rf) magnetron sputtering in an oxygen environment. The films were deposited onExpand
  • 56
An Inkjet Printed RFID-Enabled Humidity Sensor on Paper Based on Biopolymer
WPID5185575. The sensitive material is wheat gluten which is a biopolymer having electrical parameters correlated with relative humidity (RH). The sensor is validated with simulation and measurementExpand
  • 6
  • PDF
Wet-etching fabrication of multilayer GaAlAs/GaAs microtips for scanning near-field optical microscopy
Abstract.We propose to fabricate GaAlAs/GaAs multilayer microtips for scanning near-field optical microscopy (SNOM) using anisotropic etching. The etching was performed in a solution ofExpand
  • 17
X-ray diffraction studies of electrostatic sprayed SnO2: F films
TLDR
Fluorine-doped tin oxide films were deposited by electrostatic spray pyrolysis technique on 1cmx1cm Corning 7059 substrates. Expand
  • 17
Development of ruthenium dioxide electrodes for pyroelectric devices based on lithium tantalate thin films
Abstract The aim of this paper is the study of ruthenium dioxide (RuO 2 ) films, grown on low-stress silicon nitride on silicon (SiN x /Si), in order to develop thermal micro-sensors based onExpand
  • 19
PbTiO3 thin films grown by mixed reactive thermal co-evaporation
This paper describes the growth conditions and the structural characterization of thin films PbTiO 3 elaborated by a mixed reactive thermal co-evaporation. In a same chamber, in oxygen atmosphere,Expand
  • 4