• Publications
  • Influence
SELECTION OF THE OPTIMAL PARAMETERS FOR LASER CUTTING
The current high requirements for quality, accuracy and durability of produced parts lead to a permanent improvement of the production process. For reasons of efficiency and competitiveness haveExpand
Influence of cutting parameters on heat affected zone after laser cutting
Přispěvek se zabýva metodou tepelneho děleni materialu, konkretně laserovou technologii. V teoreticke casti je popsan jeji princip, funkce, možnosti a využiti laseru při obraběni, předevsim postupExpand
Impact of rainfall intensity on the hydrological performance of erosion control geotextiles
The impact of erosion control geotextiles on the surface runoff from slopes is quite variable and depends strongly on site-specific conditions (soil characteristics, slope morphology, climate, etc.),Expand
Cutting tool wear monitoring with the use of impedance layers
Nadzor trosenja reznog alata upotrebom otpornih slojeva Prethodno priopcenje Clanak se bavi problemima nadzora procesa rezanja u stvarnom vremenu. Usmjeren je na trosenje alata pomocu otpornihExpand
FOR CARBON CAPTURE AND STORAGE TECHNOLOGIES
Carbon dioxide produced by human activities is one of the major contributors to the greenhouse effect. A way to reduce air pollution could be CCS Carbon Capture and Storage Technology. Some of theExpand
The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625
Rad se bavi postupkom rezanja super legure nikla i odabirom odgovarajucih parametara rezanja za njezino lako i ucinkovito rezanja. U eksperimentalnom dijelu predlažu se tri izmjenljive plocice iExpand
INFLUENCE OF FOCUSING TUBE WEAR ON VIBRATIONS AND SURFACE ROUGHNESS
Original scientific article The paper deals with the study of the focusing tube wear influence on surface quality and vibrations produced by abrasive waterjet by means of experiments design. TheExpand
Surface Roughness after Machining and Influence of Feed Rate on Process
The aim of the work is find out influence of feed rate on the quality for the machined surface, especially surface roughness. The experiment was carried out by cutting tool HURCO VMXt30 with respectExpand
Acoustic chamber length performance analysis in ultrasonic pulsating water jet erosion of ductile material
Abstract Ultrasonic pulsating water jets are a technological modification of water jet technologies that disintegrate materials at pressures ≤100 MPa. Disintegration occurs at a non-systematicallyExpand
The effectiveness of jute and coir blankets for erosion control in different field and laboratory conditions
Abstract. Vegetation cover is found to be an ideal solution to most problems of erosion on steep slopes. Biodegradable geotextiles (GTXs) have been proved to provide sufficient protection againstExpand
...
1
2
3
4
5
...