• Publications
  • Influence
A dynamic surface roughness model for face milling
Abstract This paper presents a newly developed mathematical model for surface roughness prediction in a face-milling operation. The model considers the static and the dynamic components of theExpand
  • 77
  • 2
Multi-layer surface modification of pancreatic islets for magnetic resonance imaging using ferumoxytol.
Ferumoxytol is the only clinically available ultrasmall superparamagnetic iron oxide. However, the labeling efficacy of islet magnetic resonance imaging (MRI) using ferumoxytol is not suitable forExpand
  • 1
Determination of brittleness of brittle silicon in micro-end-milling process
At room temperature, silicon is inherently brittle, i.e. no dislocation activity occurs at or near the crack tip. A number of technological barriers must be overcome if micro-end-milling is appliedExpand
Cutting Force Analysis to Determine the Performance of Micro End Milling Process of Silicon Wafer
There is a lack of fundamental understanding of micro-end-milling of silicon wafer, specifically basic understanding of material removal mechanism, cutting forces and machined surface integrity inExpand
  • 1
Investigation on the Size Effect and Cutting Force Coefficients in Micro End Milling Process
With the global trend toward miniaturization, the demand of miniaturized components has significantly increased in a wide range of industries. As one of promising and suitable micro-manufacturingExpand
Thick SU-8 Mask for Micro Channeling of Glass by using Micro Abrasive Jet Machining
In this paper, we present the implementation of thick SU-8 layer as a mask for micro abrasive jet machining (micro- AJM) process. We obtained micro channel with aspect ratio 0.33. The micro channelExpand
  • 3
Temperature Variation Analysis of a Coolant Level Using Multiple Comparisons for Green Turning Process
Tukey method of multiple comparisons was proposed to decide the adequate amount of coolant re Tukey method of multiple comparisons was proposed to decide the adequate amount of coolant required inExpand
  • 3
Parameter identification for a single-degree-of-freedom system using autoregressive moving average model: Application to cutting system
This paper presents parameter identification for the single-degree-of-freedom (SDOF) system. The proposed method uses an autoregressive moving average (ARMA) model and a bisection method with theExpand
  • 3