Gerrit Brem

Learn More
Chromium speciation is vital for the toxicity of products resulting from co-combustion of coal and biomass. Therefore, understanding of formation processes has been studied using a combination of X-ray absorption fine structure (XAFS) spectroscopy and thermodynamic equilibrium calculations. The influence of cofiring on Cr speciation is very dependent on the(More)
Bio-oil produced from conventional flash pyrolysis has poor quality and requires expensive upgrading before it can be used as a transportation fuel. In this work, a high quality bio-oil has been produced using a novel approach where flash pyrolysis, catalysis and fractionation of pyrolysis vapors using two stage condensation are combined in a single process(More)
Torrefaction is a thermochemical pre-treatment process for upgrading the properties of biomass to resemble those of fossil fuels such as coal. Biomass properties of particular interest are chemical composition, physical property and combustion characteristics. In this work, torrefaction of beech wood and miscanthus (sinensis) was carried out to study the(More)
  • Gerrit Brem
  • DTW. Deutsche tierarztliche Wochenschrift
  • 2004
Traceability of meat has become a very important aspect of quality assurance of food. DNA analyses could be used for identification and verification of farm animals and animal derived products. A prerequisite is the collection of qualified samples from entire populations of production animals or from regionally or specially characterised animal populations.(More)
Carbon dioxide capture and storage will involve substantial capital expenditure, will involve a significant power plant cycle efficiency penalty, and is not currently available on a fully commercial basis. Biomass co-firing has a number of attractions, viz: • The technology is commercially available and reasonably well established, particularly in Northern(More)
A composite sorbent based on porous glass beads modified with thin polyaniline coating was prepared by precipitating aniline polymerization in the presence of carrier particles. It was shown that the modification ensures the uniform coating of the inner surface of the carrier pores with the polymer layer ∼70 Å thick. It was shown that the resulting material(More)
The influence of the co-combustion of household waste with either sewage sludge, shredder fluff, electronic and electrical waste (WEEE) or PVC on the bottom ash quality and content was investigated under controlled laboratory conditions using a pot furnace. This laboratory approach avoids the interpretation problems related to large variations in input(More)
To gain insight in the startup of an incinerator, this article deals with piloted ignition. A newly developed model is described to predict the piloted ignition times of wood, PMMA and PVC. The model is based on the lower flammability limit and the adiabatic flame temperature at this limit. The incoming radiative heat flux, sample thickness and moisture(More)
Upgrading of biomass pyrolysis vapors over 20 wt.% Na2CO3/γ-Al2O3 catalyst was studied in a lab-scale fix-bed reactor at 500°C. Characterization of the catalyst using SEM and XRD has shown that sodium carbonate is well-dispersed on the support γ-Al2O3. TGA and (23)Na MAS NMR suggested the formation of new hydrated sodium phase, which is likely responsible(More)
The concept of using pyrolysis oil (PO) derived from biomass via a fast pyrolysis route for power and heat generation encounters problems due to an incompatibility between properties (physical and chemical) of bio-oil and gas turbines designed for fossil fuels. An extensive research has been performed on the production and improvement of pyrolysis oil but(More)