• Publications
  • Influence
FlashCam: a fully-digital camera for the medium-sized telescopes of the Cherenkov Telescope Array
The FlashCam group is currently preparing photomultiplier-tube based cameras proposed for the medium-sized telescopes (MST) of the Cherenkov Telescope Array (CTA). The cameras are designed around theExpand
  • 14
  • 2
  • Open Access
On the robustness of the Slotine-Li and the FPT/SVD-based adaptive controllers
A comparative study concerning the robustness of a novel, Fixed Point Transformations/Singular Value Decomposition (FPT/SVD)-based adaptive controller and the Slotine-Li (S&L) approach is given byExpand
  • 20
  • Open Access
Artificial intelligence in monitoring and the mechanics of machining
Abstract The paper analyzes the role of monitoring in the manufacturing process, gives a critical review of the techniques currently used and summarizes where artificial intelligence can be used. ItExpand
  • 8
Construction of a low cost submicron measuring probe
  • G. Hermann
  • Computer Science
  • IEEE 8th International Symposium on Intelligent…
  • 29 November 2010
tl;dr
The paper describes the construction of a low cost tabtile probe with optical displacement and angular sensors. Expand
  • 2
FlashCam: A fully digital camera for the Cherenkov Telescope Array
tl;dr
FlashCam is a Cherenkov camera development project centered around a fully digital trigger and readout scheme with smart, digital signal processing and a "horizontal" architecture for the electromechanical implementation. Expand
  • 5
  • Open Access
Application of Neural Network Based Sensor Fusion in Drill Monitoring
Abstract: The detection of tool failure is crucial point in intelligent manufacturing. The lifetime of large cutting tools can be forecasted but the failure of small sized tools is nearlyExpand
  • 5
  • Open Access
Calibration system for tactile measuring probes
  • G. Hermann, I. Rudas
  • Computer Science
  • IEEE 13th International Symposium on Intelligent…
  • 12 November 2015
tl;dr
Information about procedures and equipment for the calibration of linear displacement probes are rare in the literature. Expand
  • 1
Various approaches to measurement uncertainty: A comparison
  • Gy. Hermann
  • Computer Science
  • IEEE 9th International Symposium on Intelligent…
  • 3 October 2011
tl;dr
The paper describes the various approaches to measurement uncertainty, namely the traditional probabilistic, the interval and the fuzzy approaches. Expand
  • 3
Design of a 2D High Precision Motion Stage
  • Gy. Hermann
  • Physics
  • 2nd International Symposium on Logistics and…
  • 1 September 2009
A small scale, high precision positioning table was developed to solve measurement problems originating from microtechnic. A construction with a single reference surface prefered and vacuum preloadedExpand
A HIERARCHICALLY CONTROLLED EXPERIMENTAL MANUFACTURING CELL
This paper describes the problems and their solutions raised during the design and establishment of an experimental computer controlled manufacturing cell. It consists of a number of machine toolsExpand