Fatima Sánchez Aguilera

Learn More
OBJECTIVES To evaluate resin-dentine bond degradation after 1 year of water storage. METHODS Human dentine surfaces were bonded with two etch-and-rinse self-priming adhesives (Single Bond/SB and Prime & Bond NT/PBNT), three 2-step self-etching adhesives (Clearfil SE Bond/SEB, Resulcin Aqua Prime/RES and Non-Rinse Conditioner with Prime & Bond(More)
OBJECTIVE To evaluate the effect of an in vitro challenge (NaOCl immersion) on microtensile bond strength (MTBS) of five adhesive systems to dentin. METHODS Flat dentin surfaces from 40 molars were bonded with three total-etch adhesives (Single Bond, Prime&Bond NT and the experimental Prime&Bond XP), and two self-etching agents (Clearfil SE Bond and(More)
OBJECTIVE To evaluate the effect of mechanical loading on the microtensile bond strength (MTBS) of five adhesive systems to dentin. METHODS Flat dentin surfaces from human molars were divided into five groups and bonded with total-etch self-priming adhesives (Single Bond, Prime&Bond NT and Prime&Bond XP), two-step self-etching primer (Clearfil SE Bond)(More)
In ethanol wet bonding, water is replaced by ethanol to maintain dehydrated collagen matrices in an extended state to facilitate resin infiltration. Since short ethanol dehydration protocols may be ineffective, this study tested the null hypothesis that there are no differences in ethanol dehydration protocols for maintaining the surface roughness, fibril(More)
INTRODUCTION Teeth are continuously subjected to stresses during mastication, swallowing and parafunctional habits, producing a significant reduction of the bonding efficacy in adhesive restorations. The purpose of this study was to evaluate the metalloproteinases (MMPs)-mediated dentin collagen degradation of hybrid layers created by using different(More)
OBJECTIVES To evaluate the longevity of resin-dentin bonds of three adhesives using different storage media and specimen size. METHODS Flat dentin surfaces from extracted human third molars were bonded with: a two-step etch-and-rinse self-priming adhesive (Single Bond), a two-step self-etching adhesive (Clearfil SE Bond), and a one-step self-etching(More)
The study evaluated the influence of different luting materials on the microtensile bond strength of glass fiber posts to root canal dentin. Thirty extracted maxillary premolars were endodontically treated, and the roots were prepared for post cementation using the FRC Postec system (Vivadent). Two luting materials (Multilink, Vivadent and Clearfil Photo(More)
OBJECTIVES To evaluate the microtensile bond strength (MTBS) of self-etch (with or without H(3)PO(4)-etching) and total-etch bonding systems bonded to different regions of dentin. METHODS Long flat dentin cavity preparations extending from top-crown to root-apex within the same tooth were performed and bonded: using two-step (Clearfil SE Bond/SEB,(More)
OBJECTIVES To evaluate the effect of shortening the etching time on roughness, microhardness and bond strength of three adhesive systems to primary tooth dentin. METHODS Flat dentin surfaces from primary molars were randomly assigned to six experimental groups. Three different adhesive systems were used: an etch-and-rinse adhesive (Single Bond), a(More)
This study investigated the microtensile bond strength (microTBS) of a one-step self-etching adhesive to human dentin and bovine enamel following different bonding treatments. Occlusal portions of human molars and labial surfaces of bovine incisors were ground flat to provide uniform dentin and enamel surfaces, respectively. Futurabond was used following(More)