• Publications
  • Influence
Recent advances in automotive catalysis for NOx emission control by small-pore microporous materials.
TLDR
This review briefly discusses the structure and preparation of the CHA structure-based zeolite catalysts, and summarizes the key learnings of the rather extensive (but not complete) characterisation work, and provides some mechanistic details emerging from these investigations. Expand
Damage accumulation in woven-fabric CFRP laminates under tensile loading: Part 1. Observations of damage accumulation
Abstract Damage development in composite laminates reinforced with two-, four- and six-layer carbon-fibre-reinforced polyimide eight-harness satin-weave fabric has been observed as a function ofExpand
Microwave drying of a low-rank sub-bituminous coal
Abstract The moisture contents of coals are often too high and need to be reduced before further processing. In this study, the application of microwave radiation as an alternative energy source forExpand
Mechanical properties evolution of Sn-3.5Ag based lead-free solders by nanoindentation
Abstract The mechanical properties of some promising Sn-3.5Ag based lead-free solders, such as hardness and Young's modulus, were explored by instrumented nano-indentation. It was found that theExpand
The Frictional Behavior of Thin Halide Films on Iron
The frictional behavior of thin (< 1 μ m) sodium chloride, potassium chloride, and potassium iodide films deposited onto iron has been measured in ultrahigh vacuum. It has been shown previously thatExpand
Effect of TiNi in dry sliding wear of laser melt deposited Ti2Ni/TiNi alloys
Abstract Wear resistant TiNi-based intermetallic alloys reinforced by isolated irregular Ti2Ni particles were fabricated by a laser melt deposition process. The alloy Ti50Ni50 included Ti2Ni and B2Expand
Pressure Dependence of Shear Strengths of Thin Films on Metal Surfaces Measured in Ultrahigh Vacuum
The friction coefficient is measured for systems consisting of a thin potassium chloride film deposited onto a variety of clean, flat metal substrates, namely Pb, Sn, Au, Ag, Cu, Pd, Fe, Ta, and twoExpand
The surface and tribological chemistry of chlorine- and sulfur-containing lubricant additives
Abstract A model for the operation of chlorinated hydrocarbon extreme-pressure additives is outlined in which the chlorinated hydrocarbon thermally decomposes at the hot (~1000 K) interface forming aExpand
The Tribological Properties of Low-friction Hydrogenated Diamond-like Carbon Measured in Ultrahigh Vacuum
In this paper, we investigate the sliding friction and wear behavior of a hydrogenated diamond-like carbon (DLC) film in ultrahigh vacuum (UHV) and under partial pressures of water vapor, oxygen,Expand
...
1
2
3
4
5
...