• Publications
  • Influence
Effects of two amine reducing agents on the degree of conversion and physical properties of an unfilled light-cured resin.
  • K. Yoshida, E. Greener
  • Materials Science, Medicine
  • Dental materials : official publication of the…
  • 1 July 1993
The influence of varying concentrations of two amine reducing agents commonly used in commercial light-cured composites, N,N-dimethyl-p-toluidine (DMPT) and 2-(N,N-dimethylamino)ethyl methacrylateExpand
  • 64
  • 8
The effect of resin formulation on the degree of conversion and mechanical properties of dental restorative resins.
The goal of this study was to determine the effects of resin formulation variables, such as diluent concentration, catalyst type and concentration and cure mode, on the degree of conversion of carbonExpand
  • 517
  • 7
Ultraviolet light-induced yellowing of dental restorative resins.
6. Craig RG: Restorative Dental Materials, ed 6. St. Louis, 1980, The CV Mosby Co. Council on Dental Materials and Devices: Revised American Dental Association specification No. 19 for non-aqueous,Expand
  • 135
  • 7
Correlation between degree of conversion, filler concentration and mechanical properties of posterior composite resins.
  • K. Chung, E. Greener
  • Materials Science, Medicine
  • Journal of oral rehabilitation
  • 1 September 1990
The degree of conversion, filler concentration and mechanical properties of seven proprietary light-cured posterior composite resins were investigated. The degree of conversion of composites rangedExpand
  • 238
  • 5
Effect of photoinitiator on degree of conversion of unfilled light-cured resin.
In general, the concentrations of photosensitizer and reducing agent in light-cured dental polymers are fixed by manufacturers for a specific product. These concentrations vary from product toExpand
  • 103
  • 3
  • PDF
Fourier Transform Infrared Analysis of Degree of Polymerization in Unfilled Resins—Methods Comparison
Two methods of transmission Fourier Transform Infrared analysis were compared to determine the degree of polymerization (DP) in unfilled Bis-GMA-based dental resins. Diluent concentration, curingExpand
  • 264
  • 2
Studies of Ti alloys for dental castings.
Casting of Ti has been recently investigated in dentistry. The purpose of this study was to examine the alloying effect on the cast Ti. Metallurgical structures, mechanical properties, and in vitroExpand
  • 149
  • 2
Casting Pure Titanium into Commercial Phosphate-bonded SiO2 Investment Molds
Pure titanium was cast into five different phosphate-bonded SiO2 investment mold materials (at 350°C) with an argon-arc melting and pressure casting machine. The mesh castability, the fit of the MODExpand
  • 85
  • 2
In Vivo and In Vitro Corrosion Products of Dental Amalgam
Corrosion products of amalgam produced in Ringer's solution were compared with products formed in vivo using scanning electron microscopy, X-ray microanalysis, and Potentiostatic anodic polarization.Expand
  • 86
  • 1
In vitro chloride corrosion behaviour of Dispersalloy.
The in vitro chloride corrosion behaviour of Dispersalloy has been investigated by anodic polarization as a function of time after trituration (ageing) and compared with conventional dental amalgam.Expand
  • 37
  • 1