• Publications
  • Influence
On stories, models and notations: Storyboard creation as an entry point for model-based interface development with UsiXML
TLDR
A storyboard meta-model is presented that captures the high level information from a storyboard and allows relating this information with other models that are common for engineering interactive systems and can be used as an entry point for using UsiXML models. Expand
Analysis of relation between the 3D printer laser beam power and the surface morphology properties in Ti-6Al-4V titanium alloy parts
Additive technologies are increasingly widespread in the aviation industry, medicine and implantology. It is essential that the parts manufactured for these applications meet the highest requirementsExpand
INDUSTRIAL ROBOT REPEATABILITY TESTING WITH HIGH SPEED CAMERA PHANTOM V2511
TLDR
Methodology for robot positioning accuracy measurements based on vision technique is presented and the results of measurements obtained provided data for the calculation of positioning accuracy of the robot, which was then juxtaposed against robot specifications. Expand
Assessment of internal defects of hardfacing coatings in regeneration of machine parts
This paper presents the use of computed tomography for the evaluation of hardfacing. The method used in this research is hardfacing by tungsten inert gas using alloy wires of wear resistant layers.Expand
Uncertainty measurement with the kinematic telescopic bar during industrial robot inaccuracy tests
TLDR
The method of research and calculation precisely identified key uncertainties allowing for an objective assessment of the industrial robot errors carried out with Renishaw the kinematic telescopic bar. Expand
SHEARING STRENGTH TEST OF ORTHOPAEDIC TITANIUM ALLOY SCREW PRODUCED IN THE PROCESS OF 3 D PRINTING TECHNOLOGY
The aim of the present article is the assessment of technical shear resistance (technological shear) of orthopedic screw made of titanium alloy Ti6Al4V, produced using incremental technology in theExpand
Estimation of uncertainty of laser interferometer measurement in industrial robot accuracy tests
TLDR
The authors proposed their own research methodology, taking into account measurement capabilities of the applied system and the specific character of the robot work, and precisely defined key uncertainties allowing for objective evaluation of industrial robot errors identified by the Renishaw XL80 system. Expand
Industrial Robot Accuracy Testing with QC20-W Ballbar Diagnostic System
Jerzy Józwik1, Ivan Kuric2, Dawid Ostrowski 3, Krzysztof Dziedzic4 1Department of Production Engineering, Mechanical Engineering Faculty, Lublin University of Technology, 36Nadbystrzycka Street,Expand