• Publications
  • Influence
Electrical, optical, and structural properties of indium–tin–oxide thin films for organic light-emitting devices
High-quality indium–tin–oxide (ITO) thin films (200–850 nm) have been grown by pulsed laser deposition (PLD) on glass substrates without a postdeposition annealing treatment. The structural,Expand
  • 998
  • 14
Direct-write technologies for rapid prototyping applications : sensors, electronics and integrated power sources
1. Introduction to Direct-Write Technologies for Rapid Prototyping 2. Overview of Commercial and Military Application Areas in Passive and Active Electronic Devices 3. Role of Direct-Write Tools andExpand
  • 149
  • 7
Pulsed laser deposition of thin films
Partial table of contents: History and Fundamentals of Pulsed Laser Deposition (J. Cheung). Diagnostics and Characteristics of Laser--Produced Plasmas (D. Geohegan). Particulates Generated by PulsedExpand
  • 2,175
  • 6
Laser deposition of polymer and biomaterial films.
  • 439
  • 6
Pulsed laser ablation in liquid for micro-/nanostructure generation
Abstract Pulsed laser ablation in liquid is an approach for micro-/nanostructure generation directly from bulk materials. It has grown rapidly as a research field of photochemistry and physicalExpand
  • 203
  • 6
Absorbing film assisted laser induced forward transfer of fungi (Trichoderma conidia)
We present an investigation on absorbing film assisted laser induced forward transfer (AFA-LIFT) of fungus (Trichoderma) conidia. A KrF excimer laser beam [λ=248nm,FWHM=30ns (FWHM, full width at halfExpand
  • 100
  • 4
Microwave properties of tetragonally distorted (Ba0.5Sr0.5)TiO3 thin films
A strong correlation is observed between the structure and the microwave dielectric properties of epitaxial Ba0.5Sr0.5TiO3 (BST) thin films deposited onto (001) MgO by pulsed laser deposition. FilmsExpand
  • 260
  • 4
Pulsed laser deposition of hydroxylapatite thin films on Ti‐6Al‐4V
Pulsed laser deposition was used to deposit thin films of calcium hydroxylapatite (Ca10(PO4)6(OH)2), or HA, on polished substrates of Ti-6Al-4V. Thin films of pure, crystalline HA, uncontaminated byExpand
  • 154
  • 3
Pulsed Laser Deposition of Hydroxyapatite Thin Films
Hydroxyapatite is a bioactive ceramic material that mimics the mineral composition of natural bone. This material does not possess acceptable mechanical properties for use as a bulk biomaterial;Expand
  • 120
  • 3
  • PDF
Laser transfer of biomaterials: Matrix-assisted pulsed laser evaporation (MAPLE) and MAPLE Direct Write
Two techniques for transferring biomaterial using a pulsed laser beam were developed: matrix-assisted pulsed laser evaporation (MAPLE) and MAPLE direct write (MDW). MAPLE is a large-area vacuum basedExpand
  • 129
  • 3