• Publications
  • Influence
ENTERING THE REALM OF MINERALIZED BONE PROCESSING : A REVIEW OF THE LITERATURE AND TECHNIQUES
The extensive literature describing protocols for mineralized bone and the many special techniques like processing schedules, histomorphometry, fluorochrome labeled bone, ground histology, microtom...
  • 16
  • 2
Parallel Experience of Two Different Laboratories with the Initiator Perkadox 16 for Polymerization of Methylmethacrylates
Abstract For many years, benzoyl peroxide has been used as an initiator for polymerization of methylmethacrylate. In 1983, di(4-tert-butylcyclohexyl) peroxydicarbonate, trade-named Perkadox 16, wasExpand
  • 46
  • 1
Ethylenediaminetetraacetic acid in ammonium hydroxide for reducing decalcification time.
Ethylenediaminetetraacetic acid (EDTA) solution is used to decalcify bone specimens for histological examination. Sodium hydroxide (NaOH) has been used to dissolve EDTA and to bring EDTA solutions toExpand
  • 26
  • 1
Staining Technique to Differentiate Mineralized and Demineralized Bone in Ground Sections
AbstractThe majority of stains used for routine paraffin sections and 5 μm methylmethacrylate sections do not stain ground sections well. In addition, the stains presently used for ground sections doExpand
  • 20
  • 1
Investigation of single-ion multiple-bit upsets in memories on board a space experiment
Multiple-bit upsets were observed in two types of memories operating in the radiation environment of space. They have been categorized according to their orbital location, amount of shielding andExpand
  • 41
  • 1
Comparison between SRAM SEE cross-sections from ion beam testing with those obtained using a new picosecond pulsed laser facility
A new pulsed laser facility has been developed to extend laser testing techniques to generate upset cross-section curves. The objective has been to establish an economical laser-based bulk screeningExpand
  • 26
  • 1
Comparison between SRAM SEE cross-sections from ion beam testing with those obtained using a new picosecond pulsed laser facility
A new pulsed laser facility has been developed to extend laser testing techniques to generate upset cross-section curves. The objective has been to establish an economical laser-based bulk screeningExpand
  • 20
  • 1
Radiation environment of the microelectronics and photonics test bed as measured by CREDO-3
The Cosmic Radiation Environment Dosimetry experiment is providing data on particle fluxes and linear energy transfer spectra for inner belt protons, cosmic rays and solar particles in order toExpand
  • 13
  • 1
A Historical Review of Paraffin and its Development as an Embedding Medium
This paper describes the story of the discovery of paraffin and its development from a crude wax to a refined embedding medium as we know it today. The story began in West Germany with the work ofExpand
  • 10
  • 1