Author pages are created from data sourced from our academic publisher partnerships and public sources.
- Publications
- Influence
Share This Author
Response of high performance concrete plates to impact of non-deforming projectiles
- A. N. Dancygier, D. Yankelevsky, C. Jaegermann
- Materials Science, Engineering
- 1 November 2007
Optimal regime in slip form concreting
- Z. Reichverger, C. Jaegermann
- Materials Science
- 1 March 1980
The rise rate of the form is the principal parameter of casting quality in slip form concreting. Experimental data are presented, which show that the optimal rate is the maximum one, subject to the…
Short-term steam-curing and concrete later-age strength
- I. Soroka, C. Jaegermann, A. Bentur
- Materials Science
- 4 March 1978
The effect of steam curing on later-age strength of concrete was studied on mixes having the nominal cement content of 150 to 400 kg/m3. Three series of tests were involved in which the delay period…
Effect of curing and composition on the properties of the outer skin of concrete
- A. Bentur, C. Jaegermann
- Materials Science
- 1 November 1991
The effects of curing in mild, hot, and dry conditions on strength and quality of concrete skin were studied. The skin quality was determined by absorption tests and depth of carbonation (natural and…
The evaluation of the crack-bridging ability of exposed roof coatings
- C. Jaegermann, M. Puterman
- Engineering
- 1 November 1987
A major problem with single-layerin situ applied or prefabricated roofing membranes, exposed to intensive solar radiation in subtropical climates, is their long-time ability to bridge over working…
Effect of Water-Cement Ratio and Curing on Chloride Penetration into Concrete Exposed to Mediterranean Sea Climate
- C. Jaegermann
- Materials Science
- 1 July 1990
The effect of water-cement ratio (w/c) and curing regime on chloride ion ingress of 20 x 20 x 12 cm concrete specimens exposed to Mediterranean Sea climate was studied. Variants included w/c of 0.4,…
The influence of the permeability of materials and absorption on condensation in dwellings
- R. Becker, C. Jaegermann
- Engineering
- 1982
Development of a Scratch-Test Instrument for Thick Wall Coverings
- R. Horstman, Ka Peters, M. Relis
- Engineering, Materials Science
- 1 May 1982
While establishing performance specifications for building elements, the authors have recognized the fact that there is no available test method for the direct investigation of scratch resistance of…
A simple pull-out test for in situ determination of early strength of concrete
- C. Jaegermann
- Materials Science
- 1 December 1989
The aim of the work reported was to develop a simple non-destructive testing method for monitoring strength development between 5 MPa and 15 MPa for form stripping in industrialized building.…
...
...