• Publications
  • Influence
Stable life offered by the synthetic plastic and their nonrenewable source results in waste disposal and environmental pollution. Bio degradable plastics can be obtained from various combinations ofExpand
  • 8
  • 1
Design and Analysis of Reinforced Ceramic with Epoxy Resin and Graphite
Nowadays, polymer matrix composite plays a vital role in automotive, aerospace and marine engineering. The epoxy composite was prepared using the hand layup method in room temperature. TheExpand
Dynamic Failure Mode and Effect Analysis of Driving Mechanism of Planner
The failure evaluation and optimization of horizontal mechanism in horizontal planning device rack and pinion arrangement is want for the interpretation movement. Expand
Effect of staggered bolted connections on CFS channel sections
Abstract This research focuses on the effect of staggered bolted connections on the ultimate tensile capacity and failure modes of the cold-formed steel channel sections connected to the gussetExpand
Design and development of two degree of freedom model with PID controller for turning operation
The objective is to develop a two degree of freedom model with PID controller for turning process to reduce regenerative chatter with the aim of improving productivity, quality of surface finish, tool life. Expand
  • 2
  • PDF
Comparative experimental studies on the web cleat bolted CFS beam-to-column connection
Abstract Cold-formed steel (CFS) clip angles/web cleats are widely used as connectors between two CFS members. This study aims to determine the efficiency of a three bolted web cleat over aExpand
Design and Development of TDOF System with PD Controller for Turning Operation
Active vibration control technique is very important for increasing life of various components and structures; this results in lower fatigue, better accuracy, and low maintenance. In the turningExpand
Design and Analysis of Turbocharger Impeller in Diesel Engine
The main goal of this research is to be design the turbine and compressor impeller of a turbocharger for a diesel engine. It is to increase power and efficiency of a turbocharger. It is to usage ofExpand
  • 1