• Publications
  • Influence
Polymerization capacity of orthodontic composites analyzed by Fourier transform infrared spectroscopy.
INTRODUCTION The aim of this in-vitro study was to analyze the polymerization capacity of 5 orthodontic composites by determining the degree of monomer conversion (DC). METHODS Fourier transformExpand
  • 17
Cytotoxicity evaluation of dentin bonding agents by dentin barrier test on 3-dimensional pulp cells.
OBJECTIVE The aim of this study was to evaluate the effects of 4 dentin-bonding agents on the cell viability of bovine derived cells. STUDY DESIGN Cytotoxicity of dentin-bonding agents (G-BondExpand
  • 23
  • PDF
Influence of different tooth types on the bond strength of two orthodontic adhesive systems
The aim of this investigation was to evaluate the effects of different tooth types on the shear bond strength (SBS) of two orthodontic resin adhesive systems in vitro. Two hundred extracted soundExpand
  • 18
Microtensile Bond Strength of Cad-Cam and Pressed-Ceramic Inlays to Dentin
Objectives CAD-CAM system is popular because of high esthetic and short fabrication time. But, there is limited information available about the microtensile bonding of luting cements to CAD-CAMExpand
  • 10
  • PDF
Reliability of electronically detection of fissure caries (by using a prototype device): An alternative diagnostic electronic caries monitor device
Objective: The purpose of this in vitro study was to investigate the reliability of a prototype electronic caries monitor (ECM) for diagnosis of the dental caries on the occlusal surfaces ofExpand
  • 3
Comparison of the Different Self-Adhesive Composite's Shear Bond Strength and Microleakage on Caries- Affected Dentin with Using Er:YAG Laser
ABS TRACT Objective: The aims of this study was to evaluate the bond strength of the self-adhesive composites (SAC; Vertise Flow, Fusio Liquid Dentin, Constic) on caries-affected dentin, which wasExpand
Shear Bond Strength of Three Luting Cements to Two Ceramic Materials
The aim of this study was to evaluate the shear bond strength of three different dual cure luting cements to two ceramic materials. Sixty cylindrical specimens (4mm in diameter) were prepared withExpand