• Publications
  • Influence
The machinability of nickel-based alloys: a review
Abstract This paper presents a detailed review of the various types of nickel-based alloys available on a commercial basis and their development including alloying additions as well as processingExpand
  • 519
  • 17
Machining of Titanium and its Alloys—a Review
Even though a new generation of tool materials is now available which is revolutionizing machinability of a large number of work materials, the machining of titanium continues to be a problem. In theExpand
  • 288
  • 14
Evaluation of the performance of CBN tools when turning Ti-6Al-4V alloy with high pressure coolant supplies
Abstract Cubic Nitride Boron (CBN) tools are generally used for machining harder alloys such as hardened high Cr steels, titanium and nickel alloys. The tools are expected to withstand the heat andExpand
  • 218
  • 9
Performance of cryogenically treated HSS tools
Studies on cryogenically treated high speed steel tools show microstructural changes in the material that can influence tool lives and productivity significantly. Results in the literature show toolExpand
  • 197
  • 6
The effect of extremely low lubricant volumes in machining
Abstract Cost, the effect on the environment, and health issues are all relevant when considering the choice of a lubricant and application system in a modern metal cutting process. The need to useExpand
  • 186
  • 4
The Effects of a High-Pressure Coolant Jet on Machining
A high-pressure coolant system was used to machine Ti6Al4V and Inconel 901. A 14.5 MPajet of cutting fluid was applied against the chip flow at the rake face of the tool and this works as anExpand
  • 64
  • 4
Tool life and wear mechanisms in high speed machining of Ti–6Al–4V alloy with PCD tools under various coolant pressures
Abstract Usage of titanium alloys has increased since the past 50 years despite difficulties encountered during machining. Many studies involving different tool materials, cutting parameters, toolExpand
  • 166
  • 3
Application of cutting fluids in machining processes
In the last decade a lot has been discussed about the suitability of using cutting fluid in abundance to cool and lubricate machining processes. The use of cutting fluid generally causes economy ofExpand
  • 71
  • 3
TOOL PERFORMANCE AND CHIP CONTROL WHEN MACHINING Ti6A14V AND INCONEL 901 USING HIGH PRESSURE COOLANT SUPPLY
Abstract Single point continuous turning tests were carried out on Ti6A14V and Inconel 901 using various geometries of straight grade (K20) cemented carbide inserts using a high pressure coolant jetExpand
  • 69
  • 3
Turning of Inconel 718 with whisker-reinforced ceramic tools applying vegetable-based cutting fluid mixed with solid lubricants by MQL
Abstract The rule of thumb in the machining of nickel base superalloys with ceramic tools is to cut dry and no attempt of applying MQL with the addition of solid lubricant was made, according to theExpand
  • 39
  • 2
...
1
2
3
4
5
...